Activation powder is a catalyst compound that dramatically accelerates the chemical reaction between SSD automatic solution and the dye or coating on defaced banknotes. On its own, SSD solution can take several hours to complete a full treatment cycle. When combined with the correct ratio of activation powder, treatment time can be reduced to under 30 minutes with equal or superior results. Pro Chemicals Lab activation powder is produced in small batches to ensure freshness and peak reactivity. Each container is vacuum-sealed with an inert gas purge to prevent moisture ingress, which is the primary cause of reduced catalytic activity in competing products.

What Is Vectrol Paste?

Vectrol paste is a specialized thickening and binding agent used in conjunction with SSD automatic solution for notes that cannot be fully immersed due to their condition, volume, or substrate sensitivity. The paste formulation allows the active SSD chemical components to be applied directly to the surface of affected areas and maintained in contact for the duration of the treatment cycle without runoff or evaporation loss.

When to Use Vectrol Paste Instead of Immersion?

Vectrol paste is the preferred method in the following scenarios:

• Partial coatings limited to one face of the banknote
  Notes with significant physical damage where immersion could cause further deterioration
  High-denomination notes where precision application is essential
  Field conditions where controlled immersion baths are not available
  Step-by-Step Guide: Combining SSD Automatic Solution, Activation Powder, and Vectrol Paste

   

  Step 1 — Prepare Your Workspace:

   

   

  Ensure your workspace is well-ventilated. Lay down a chemical-resistant mat. Put on nitrile gloves, safety glasses, and a lab coat before handling any laboratory chemicals.

Step 2 — Measure the Activation Powder:

For standard cleaning black money operations, use a ratio of 2 grams of activation powder per 100ml of SSD automatic solution. Use a calibrated digital scale for accuracy. Never estimate by volume — the density of activation powder can vary between batches.

Step 3 — Mix the Solution:

Add the measured activation powder to the SSD automatic solution in a glass or HDPE mixing vessel. Stir gently for 60 seconds using a glass rod. Do not use metal utensils as they may cause unwanted reactions. The solution will show a slight color change from clear to pale amber when fully activated — this is normal.

Step 4 — Apply Vectrol Paste for Surface Treatment:

If using vectrol paste for direct surface application, mix one part vectrol paste with three parts of the activated SSD solution until a uniform gel consistency is achieved. Apply a thin, even layer across the coated surface using a soft-bristle applicator brush. Allow to react for 20–30 minutes.

Step 5 — Rinse and Neutralize:

After the reaction period, rinse the treated notes gently with distilled water. Apply the neutralizing rinse included in your kit, then blot dry with lint-free tissue. Allow to air dry completely before handling under UV inspection.